Automation of Compression Testing Machine

Authors

  • Julia George  Department of Mechanical Engineering, the National Institute of Engineering, Mysuru, Karnataka, India
  • Rakesh M  Department of Mechanical Engineering, the National Institute of Engineering, Mysuru, Karnataka, India

Keywords:

Compression Testing Machine, Load cell, PLC, Database.

Abstract

The main prospective of this paper is to analyze the working and testing procedure for the automation of Compression Testing Machine (CTM). Load cells of higher weights are being manufactured which needs to be calibrated and tested for their quality. Here Mitsubishi PLC are used to automate the setup. The reason for automating the setup is to reduce the human interference and to get the expected results. The data which observed during calibration and testing of the machine is then stored in the database.

References

  1. Fei Hu , Wenqing Yin , Cairong Chen “ Design of the tensile testing machine computer control system based on MCGS” 2010 International Conference on Challenges in Environmental Science and Computer Engineering.
  2. WANG Jian-xin, “Development of universal testing machine remote test and detection system,” Journal of Transducer Technology, vol. 23, May. 2014, pp. 29-31.
  3. “Universal Testing Machine Motion Control System” by Sagar S Patel, Gayathri K M 2013.
  4. “Graphical User Interface for Universal Testing Machine Using Qt” by Gore Snehalata Shivajirao, Y. B. Mane. 2017.

IInternational Journal of Scientific Research in Computer Science, Engineering and Information Technology

Downloads

Published

2018-05-08

Issue

Volume 4, Issue 6, May-June-2018

Section

Research Articles

License

Copyright (c) IJSRCSEIT

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Julia George, Rakesh M, " Automation of Compression Testing Machine, IInternational Journal of Scientific Research in Computer Science, Engineering and Information Technology(IJSRCSEIT), ISSN : 2456-3307, Volume 4, Issue 6, pp.634-639, May-June-2018.