Electronic Pollution Under Controll
Keywords:
Sensors, GSM, ControllerAbstract
Every vehicle has its own emission of gases, but the problem occurs when the emission is beyond the standardized values. The primary reason for this breach of emission level being the incomplete combustion of fuel supplied to the engine which is due to the improper maintenance of vehicles. This emission from vehicles cannot be completely avoided, but it definitely can be controlled .The aim of the project is to monitor the pollutants in the vehicle by using the pollution control circuit. This pollution control circuit consists of various sensors like smoke sensors and all of them are integrated and connected to a Controller. It is a real time work where a demo application has been made in which PIC micro controller is used and a controller board is made where all these devices get integrated and work accordingly. When a vehicle attains certain threshold pollution level then the engine gets automatically switched off and an SMS is generated and sent to the pre-defined number stored in the memory through the GSM module.
References
- http://wikipedia.org/wiki/Bharat_Stage_emission_standards
- George F. Fine, Leon M. Cavanaugh, Ayo Afonja and Russell Binions " Metal Oxide Semi-Conductor Gas Sensors in Environmental Monitoring", Sensors 2010, 10, 5469-5502; doi:10.3390/s100605469
- Galatsis, W. Wlodarsla, K. Kalantar-Zadeh and A. Trinchi "Investigation of gas sensors for vehicle cabin air quality monitoring," vol. 42, pp. 167-175, 2002.
- “Trade of Motor Mechanic"; Module 5; Unit 2 Electronic Fuel injection; Phase 2 by FÁS Learning Innovation Unit with Martin McMahon & CDX Global; Curriculum Revision 2.2 16-01-07.
- LIU Zhen-ya, WANG Zhen-dong, CHEN Rong, “Intelligent Residential Security Alarm and Remote Control System Based on Single Chip Computer," vol. 42, pp. 143-166, 2008
Downloads
Published
Issue
Section
License
Copyright (c) IJSRCSEIT

This work is licensed under a Creative Commons Attribution 4.0 International License.