Heat Reducing Using Peltier Effect on Smart Phones
Keywords:
Peltier Tile, Heat Sensing Sensor, IC555 Processor, LM35,Relay, Variable Resistor, Heat SinkAbstract
This is the paper presents how the peltier effect can reduce the smart phone’s heat using a trigger circuit. A smart phone case is constructed with a peltier tile, a heat-sensing sensor, and a heat sink. That case will be get connected with a trigger circuit, which consist of some hardware like transistor, IC555processor, relay, switch, biaser, buzzer, heat sink and a variable resistor. Using these components how would be the smart phone’s heat will get reduced is a concept that this paper has been discussed
References
- Yahya Sheikhnejad, Ricardo Bastos, Zoran Vujicic, Ali Shahpari, Antonio Teixeira," Laser Thermal Tuning by Transient Analytical Analysis of Peltier Device",p.p1-5",IEEE,2016.
- Yunda Wang, David E. Schwartz, Member, IEEE, Sylvia J. Smullin, Qian Wang, and Martin J. Sheridan," Silicon Heat Switches for Electrocaloric Cooling", JOURNAL OF MICROELECTROMECHANICAL SYSTEMS, P.P1, IEEE,2017.
- Thomas Foulkes, Junho Oh, Patrick Birbarah, Jason Neely, Nenad Miljkovicy, Robert C.N. Pilawa Podgurski, "Active Hot Spot Cooling of GaN Transistors With ElectricField Enhanced Jumping Droplet Condensation",P.P 912-913, IEEE,2017.
- Daisuke Miyagi, Noriyuki Fukushima, Shuhei Sakurai, Makoto Tsuda, and Shoichi Yokoyama," Study on Thermal Measurement Method of AC Loss in a Conduction-Cooled HTS Coil", IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY,VOL.27,NO.4,P.P 1, JUNE 2017.
- Torsten Wilde, Michael Ott, Axel Auweter, Ingmar Meijer, Patrick Ruch, Markus Hilger, Steffen K¨uhnert, Herbert Huber," CooLMUC-2: A Supercomputing Cluster with Heat Recovery for Adsorption Cooling", 33rd SEMI-THERM Symposium, P.P 115-117,IEEE, 2017.
- T. Nishimura, H. Tanoue, Y. Oodate, H. 1. Mattausch, M. Miura-Mattausch," Measurement and Modeling of IC Self-Heating Including Cooling System Properties",P.P 90,IEEE,2015.
- Kaoru Furumi, Masashi Imai, Atsushi Kurokawa," Cooling Architectures using Thermal Sidewalls, Interchip Plates, and Bottom Plate for 3D ICs", 18th Int'l Symposium on Quality Electronic Design, p.p 283, IEEE, 2017.
- Gregory Paul and Edward Gim, David Westerfeld," Battery Powered Heating and Cooling Suit",P.P1-3,IEEE,2014.
Downloads
Published
Issue
Section
License
Copyright (c) IJSRCSEIT

This work is licensed under a Creative Commons Attribution 4.0 International License.